Remove a Power Supply
See
■
in the server.
See
■
supply.
Go to the rear of the server and locate the AC power connector at the rear of the
2.
server that supplies power to the faulty power supply.
See
"Power Supply Configuration" on page
3.
Disconnect that power cord.
4.
Go to the front of the server and, on the power supply to be removed, squeeze
the release latches together, then pull the extraction lever toward you to
disengage the power supply from the server.
152
SPARC T7-4 Server Service Manual • May 2017
"Front Panel Components (Service)" on page 14
"Determine Which Power Supply Is Faulty" on page 151
for the locations of the power supplies
to locate a faulty power
147.