Oracle SPARC T7-4 Service Manual page 191

Applied power to the server.
■
See "Connect Power Cords" on page
Started the system.
■
See "Power On the Server (Oracle ILOM)" on page
Verify that the System Service Required LED on the rear I/O module is not lit.
2.
See "Rear I/O Module LEDs" on page
Log in to Oracle ILOM.
3.
See "Log In to Oracle ILOM (Service)" on page
Start the faultmagmt shell.
4.
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp>
5.
Use the fmadm faulty command to determine if the server is operating normally.
If a fault was detected, see
■
If no faults were detected, then the rear I/O module has been replaced successfully. No
■
further action is required.
Related Information
"Detecting and Managing Faults" on page 25
■
"Rear I/O Module LEDs" on page 183
■
"Determine if the Rear I/O Module Is Faulty" on page 186
■
"Remove the Rear I/O Module" on page 186
■
"Install the Rear I/O Module" on page 188
■
201.
183.
32.
"Diagnostics Process" on page
Verify the Rear I/O Module
202.
26.
Servicing the Rear I/O Module 191