Disconnect The Nvme Cables - Oracle SPARC T7-4 Service Manual

Disconnect the NVMe Cables

Caution -
discharge. This discharge can cause failure of server components.
"Disconnect the NVMe Cables" on page 112
■
"Remove a NVMe Switch Card" on page 113
■
"Install a NVMe Switch Card" on page 114
■
"Connect the NVMe Cables" on page 117
■
"Verify a NVMe Switch Card" on page 117
■
Disconnect the NVMe Cables
Remove the main module.
1.
See "Remove the Main Module" on page
2. Determine your next step:
If you are replacing a faulty NVMe switch card, unplug the NVMe cables from
■
the card.
If you are moving the NVMe switch cards to a new main module, unplug the
■
cables from the backplane.
If you are replacing the NVMe cables, unplug the cables from the card and
■
the backplane and remove them from the main module.
112 SPARC T7-4 Server Service Manual • May 2017
This procedure requires that you handle components that are sensitive to electrostatic
101.