Install A Processor Module Or Processor Filler Module - Oracle SPARC T8-4 Service Manual

a. Remove all of the DIMMs from the faulty processor module, and set
them in a safe place.
See
b. Install the DIMMs into the new processor module.
See
c. Install the processor module.
See
If you have removed a processor filler module as part of a server upgrade,
■
return to
If you have removed a processor module or processor filler module to
■
prepare the server for installation, return to
SPARC T8-4 Server Installation Guide
Related Information
"Processor Module Components" on page 18
■
"Processor Module LEDs" on page 58
■
"Server Upgrade Process" on page 56
■
"Determine Which Processor Module Is Faulty" on page 59
■
"Servicing DIMMs" on page 69
■
"Install a Processor Module or Processor Filler Module" on page 63
■
"Verify a Processor Module" on page 67
■

Install a Processor Module or Processor Filler Module

Processor modules are cold-service components that can be replaced only by qualified
service personnel. For the location of the processor modules, see
Components" on page
You must disconnect the power cords before servicing this component. See
Caution -
"Disconnect Power Cords" on page
"Remove a DIMM" on page
"Install a DIMM" on page
"Install a Processor Module or Processor Filler Module" on page
"Server Upgrade Process" on page
14.
53.
Install a Processor Module or Processor Filler Module
78.
81.
56.
"Preparing for Installation" in
.
"Front Panel
Servicing Processor Modules
63.
63