Verify The Main Module - Oracle SPARC T7-4 Service Manual

Verify the Main Module

b. Download the system firmware.
Follow the firmware download instructions in the Oracle ILOM documentation.
Note -
that had been installed prior to the replacement of the main module. However, Oracle strongly
recommends installing the newest version of the system firmware.
Restore the ILOM configuration settings.
c.
Refer to the
Power on the server.
8.
See "Returning the Server to Operation" on page
Related Information
"Main Module Components" on page 20
■
"Main Module LEDs" on page 100
■
"Remove the Main Module" on page 101
■
Verify the Main Module
1. Verify that the main module Service Required LED is not lit.
See "Main Module LEDs" on page
2. Verify that the front and rear System Service Required LEDs are not lit.
See "Front Panel Controls and LEDs" on page 29
LEDs" on page
3. Consider these options.
If the previous steps did not clear the fault, see
■
If the previous steps indicate that no faults have been detected, then the main module has
■
been replaced successfully. No further action is required.
Related Information
"Main Module LEDs" on page 100
■
"Determine if the Main Module Is Faulty" on page 101
■
108 SPARC T7-4 Server Service Manual • May 2017
You can load any supported system firmware version, including the firmware revision
ILOM documentation
31.
(http://www.oracle.com/goto/ILOM/docs).
201.
100.
and "Rear Panel Controls and
"Diagnostics Process" on page 26.