Oracle SPARC T7-4 Service Manual page 130

Install the SPM
Refer to the Oracle ILOM documentation for network configuration instructions.
b. Download the system firmware.
Follow the firmware download instructions in the Oracle ILOM documentation.
Note -
that had been installed prior to the replacement of the SPM. However, Oracle strongly
recommends installing the newest version of the system firmware.
7. Restore the service processor configuration information that you backed up
earlier.
At the Oracle ILOM prompt, type:
-> cd /SP/config
-> load -source uri target
where:
■ The acceptable values for uri are:
■
■
■
■
■
■
target is the remote location where you stored the configuration information.
■
For example:
-> load -source tftp://129.99.99.99/pathname
8. If TPM was initialized on the replaced SPM, complete these steps:
a.
Reinitialize TPM and reset the tpmadm failover command if it was previously
in use.
For information about initializing TPM using the Oracle ILOM interface to enable failover,
see
130 SPARC T7-4 Server Service Manual • May 2017
You can load any supported system firmware version, including the firmware revision
tftp
ftp
sftp
scp
http
https
Securing Systems and Attached Devices in Oracle Solaris 11.3.