Pre-Configured Ip-To-Ip Routing Rules; Normal Mode - AudioCodes Mediant 1000B User Manual

39.4

Pre-Configured IP-to-IP Routing Rules

For the CRP application, the IP-to-IP Routing table is pre-configured with IP-to-IP routing
rules. These rules depend on the configured Call Survivability mode, as described in
'Configuring Call Survivability Mode' on page 698.
Notes:
•
The IP-to-IP Routing table is read-only.
•
For accessing the IP-to-IP Routing table and for a description of its parameters,
see 'Configuring SBC IP-to-IP Routing Rules' on page 643.

39.4.1 Normal Mode

The pre-configured IP-to-IP routing rules for the Normal CRP call survivability mode are
shown in the table below:
Table 39-2: Pre-Configured IP-to-IP Routing Rules for CRP Normal Mode
Index Source IP
Group /
Emergency
1 *
3 1
4 1
5 1
6 2
1
7 2
8 3
9 3
Note:
1. Index 7 appears only if the CRPGatewayFallback parameter is enabled (see
'Configuring PSTN Fallback' on page 702). This routing rule is used if the device can't
find a matching destination user for IP Group 1 (User-type IP Group) in its registration
database. If the CRPGatewayFallback parameter is disabled and no matching user is
find, the device rejects the call.
User's Manual
Request Destination
Type Type
OPTIONS Dest
Address
All IP Group
All IP Group
All IP Group
All IP Group
All IP Group
All IP Group
All IP Group
Mediant 1000B Gateway and E- SBC
Destination Destination
IP Group Address
- Internal
2
1
3
1
3
2
1
700
Alternative Route
Options
Route Row
- Route Row
- Alternative
- Alternative
- Route Row
- Route Row
- Route Row
- Alternative
Document #: LTRT-27044