Viewing Syslog Messages - AudioCodes Mediant 1000B User Manual

User's Manual

52.2.6 Viewing Syslog Messages

You can receive and view Syslog messages generated by the device using any of the
following Syslog server types:

Wireshark - third-party network protocol analyzer (http://www.wireshark.org).
Note:
the debug recording, to view Syslog messages using Wireshark, you must install
AudioCodes' Wireshark plug-in (acsyslog.dll). Once the plug-in is installed, the Syslog
messages are decoded as "AC SYSLOG" and displayed using the "acsyslog" filter
(instead of the regular "syslog" filter). For more information on debug recording, see
'Debug Recording' on page 851.

Third-party, Syslog Server: Any third-party Syslog server program that enables
filtering of messages according to parameters such as priority, IP sender address,
time, and date.

Device's CLI Console: The device sends the error messages (e.g. Syslog messages)
to the CLI console as well as to the configured destination. Use the following
commands:
debug log
no debug log
no debug log all

Device's Web Interface: The device provides an embedded Syslog server, which is
accessed through the Web interface (Status & Diagnostics tab > System Status
menu > Message Log). This provides limited Syslog server functionality.
The displayed logged messages are color-coded as follows:
•
Yellow - fatal error message
•
Blue - recoverable error message (i.e., non-fatal error)
•
Black - notice message
To stop and clear the Message Log, close the Message Log page by accessing any
another page in the Web interface.
Version 7.0
When debug recording is enabled and Syslog messages are also included in
; Starts the debug
; Stops the debug
; Stops all debug process
Figure 52-6: Message Log Page
52. Syslog and Debug Recording
849 Mediant 1000B Gateway and E- SBC