Remote Pbx Extension Between Fxo And Fxs Devices - AudioCodes Mediant 1000B User Manual

User's Manual

Automatic dialing is enabled: if the remote party doesn't answer the call and the
ringing signal stops for a user-defined time (using the parameter
FXOBetweenRingTime), the FXO device releases the IP call.
Ring Detection Timeout supports full ring cycle of ring on and ring off (from ring start to ring
start).
27.14 Remote PBX Extension between FXO and FXS
Devices
Remote PBX extension offers a company the capability of extending the "power" of its local
PBX by allowing remote phones (remote offices) to connect to the company's PBX over the
IP network (instead of via PSTN). This is as if the remote office is located in the head office
(where the PBX is installed). PBX extensions are connected through FXO ports to the IP
network, instead of being connected to individual telephone stations. At the remote office,
FXS units connect analog phones to the same IP network. To produce full transparency,
each FXO port is mapped to an FXS port (i.e., one-to-one mapping). This allows individual
extensions to be extended to remote locations. To call a remote office worker, a PBX user
or a PSTN caller simply dials the PBX extension that is mapped to the remote FXS port.
This section provides an example on how to implement a remote telephone extension
through the IP network, using FXO andFXS interfaces. In this configuration, the FXO
device routes calls received from the PBX to the 'Remote PBX Extension' connected to the
FXS device. The routing is transparent as if the telephone connected to the FXS device is
directly connected to the PBX.
The following is required:

FXO interfaces with ports connected directly to the PBX lines (shown in the figure
below)

FXS interfaces for the 'remote PBX extension'

Analog phones (POTS)

PBX (one or more PBX loop start lines)

LAN network
Version 7.0 577 Mediant 1000B Gateway and E- SBC
27. Analog Gateway