Three-Way Conferencing Parameters - AudioCodes Mediant 1000B User Manual

Parameter
59.10.5.8

Three-Way Conferencing Parameters

The three-way conferencing parameters are described in the table below.
Parameter
Enable 3-Way
Conference
enable-3w-conf
[Enable3WayConference]
3-Way Conference Mode
3w-conf-mode
[3WayConferenceMode]
User's Manual
ISDNSuppServ_IsPresentationRestricted,
ISDNSuppServ_IsCallerIDEnabled;
[ \ISDNSuppServ ]
For a detailed description of the table, see 'Configuring Multi-Line
Extensions and Supplementary Services' on page 544.
Table 59-49: Three-Way Conferencing Parameters
Enables the 3-Way Conference feature.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is required.
Defines the mode of operation for three-way conferencing.

[0] AudioCodes Media Server = (Default) The conference-initiating
INVITE sent by the device, uses the ConferenceID concatenated
with a unique identifier as the Request-URI. This same Request-URI
is set as the Refer-To header value in the REFER messages that are
sent to the two remote parties. This conference mode is used when
operating with AudioCodes IPMedia conferencing server.

[1] Non-AudioCodes Media Server = The conference-initiating
INVITE sent by the device, uses only the ConferenceID as the
Request-URI. The Conference server sets the Contact header of the
200 OK response to the actual unique identifier (Conference URI) to
be used by the participants. This Conference URI is then included by
the device in the Refer-To header value in the REFER messages
sent by the device to the remote parties. The remote parties join the
conference by sending INVITE messages to the conference using
this conference URI.

[2] On Board = On-board, three-way conference. The conference is
established on the device without the need of an external
Conference server. You can limit the number of simultaneous, on-
board 3-way conference calls, by using the
MaxInBoardConferenceCalls parameter. The device sets up the
conference call using its IP media channels. These channels are
obtained from the IP media module (i.e., MPM). Note that the device
must be housed with MPMs to support three-way conferencing. The
device supports up to five simultaneous, on-board three-way
conference calls.

[3] Huawei Media Server = The conference is managed by an
external, third-party Conferencing server. The conference-initiating
INVITE sent by the device, uses only the ConferenceID as the
Request-URI. The Conferencing server sets the Contact header of
the 200 OK response to the actual unique identifier (Conference
URI) to be used by the participants. The Conference URI is included
in the URI of the REFER with a Replaces header sent by the device
to the Conferencing server. The Conferencing server then sends an
INVITE with a Replaces header to the remote participants.
Mediant 1000B Gateway and E- SBC
Description
Description
1014 Document #: LTRT-27044