Configuring Address Of Syslog Server; Enabling Syslog - AudioCodes Mediant 1000B User Manual

automatically lowers the debug level to free up CPU resources that were required for
the previous debug-level functionality. When CPU resources become available again,
the device increases the debug level to its' previous setting. For example, if you set
the 'Debug Level' to Detailed and CPU resources decrease to the defined threshold,
the device automatically changes the level to Basic, and if that is not enough, it
changes the level to No Debug. Once CPU resources are returned to normal, the
device automatically changes the debug level back to its' original setting (i.e.,
Detailed). The threshold is configured by the DebugLevelHighThreshold parameter.
5. Click Submit.

52.2.4 Configuring Address of Syslog Server

The following procedure describes how to configure the Syslog server's address to where
the device sends the Syslog messages.

To configure the address of the Syslog server:
1. Open the Syslog Settings page (Configuration tab > System menu > Syslog
Settings).
2. In the 'Syslog Server IP Address' field, define the IP address of the Syslog server.
3. In the 'Syslog Server Port' field, define the port of the Syslog server.
4. Click Submit.

52.2.5 Enabling Syslog

The following procedure describes how to enable Syslog.

To enable Syslog:
1. Open the Syslog Settings page (Configuration tab > System menu > Syslog
Settings).
2. From the 'Enable Syslog' drop-down list, select Enable.
3. Click Submit.
User's Manual
Figure 52-4: Configuring the Syslog Address
Figure 52-5: Syslog Settings Page
848
Mediant 1000B Gateway and E- SBC
Document #: LTRT-27044