AudioCodes Mediant 1000B User Manual page 955

User's Manual
Parameter
Subject
usr-def-subject
[SIPSubject]
[CoderPriorityNegotiation]
Send All Coders on
Retrieve
send-all-cdrs-on-
rtrv
[SendAllCodersOnRetriev
e]
Multiple Packetization
Time Format
mult-ptime-format
[MultiPtimeFormat]
[EnablePtime]
Version 7.0
incremented. In scenarios such as session expires, SDP negotiation is
irrelevant and thus, the origin field is not changed.
Even though some SIP devices don't follow this behavior and don't
increment the origin value even in scenarios where they want to re-
negotiate, the device can assume that the remote party operates
according to RFC 3264, and in cases where the origin field is not
incremented, the device does not re-negotiate SDP capabilities.

[0] Disable = (Default) The device negotiates any new SDP re-offer,
regardless of the origin field.

[1] Enable = The device negotiates only an SDP re-offer with an
incremented origin field.
Defines the Subject header value in outgoing INVITE messages. If not
specified, the Subject header isn't included (default).
The maximum length is up to 50 characters.
Defines the priority for coder negotiation in the incoming SDP offer,
between the device's or remote UA's coder list.

[0] = (Default) Coder negotiation is given higher priority to the remote
UA's list of supported coders.

[1] = Coder negotiation is given higher priority to the device's (local)
supported coders list.
Note: The parameter is applicable only to the Gateway application.
Enables coder re-negotiation in the sent re-INVITE for retrieving an on-
hold call.

[0] Disable = (Default) Sends only the initially chosen coder when the
call was first established and then put on-hold.

[1] Enable = Includes all supported coders in the SDP of the re-
INVITE sent to the call made un-hold (retrieved). The used coder is
therefore, re-negotiated.
The parameter is useful in the following call scenario example:
Party A calls party B and coder G.711 is chosen.
1
Party B is put on-hold while Party A blind transfers Party B to Party
2
C.
Party C answers and Party B is made un-hold. However, as Party C
3
supports only G.729 coder, re-negotiation of the supported coder is
required.
Note: The parameter is applicable only to the Gateway application.
Determines whether the 'mptime' attribute is included in the outgoing
SDP.

[0] None = (Default) Disabled.

[1] PacketCable = Includes the 'mptime' attribute in the outgoing
SDP - PacketCable-defined format.
The mptime' attribute enables the device to define a separate
packetization period for each negotiated coder in the SDP. The 'mptime'
attribute is only included if the parameter is enabled even if the remote
side includes it in the SDP offer. Upon receipt, each coder receives its
'ptime' value in the following precedence: from 'mptime' attribute, from
'ptime' attribute, and then from default value.
Determines whether the 'ptime' attribute is included in the SDP.

[0] = Remove the 'ptime' attribute from SDP.
955
59. Configuration Parameters Reference
Description
Mediant 1000B Gateway and E- SBC