Serial Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
[SNMPUsers]

59.1.6 Serial Parameters

The serial interface parameters are described in the table below.
Parameter
[DisableRS232]
[SerialBaudRate]
[SerialData]
[SerialParity]
[SerialStop]
[SerialFlowControl]
Version 7.0
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey,
SNMPUsers_Group;
[\SNMPUsers]
For example:
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
The example above configures user 'v3admin1' with security level
authNoPriv(2), authentication protocol MD5, authentication text
password 'myauthkey', and ReadWriteGroup2.
For a description of the table, see 'Configuring SNMP V3 Users'
on page 97.
Table 59-6: Serial Parameters
Enables the device's RS-232 (serial) port.

[0] = Enabled

[1] = (Default) Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For how to establish
a serial communication with the device, refer to the Installation Manual.
Note: For the parameter to take effect, a device reset is required.
Defines the serial communication baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For the parameter to take effect, a device reset is required.
Defines the serial communication data bit.

[7] = 7-bit

[8] = (Default) 8-bit
Note: For the parameter to take effect, a device reset is required.
Defines the serial communication polarity.

[0] = (Default) None

[1] = Odd

[2] = Even
Note: For the parameter to take effect, a device reset is required.
Defines the serial communication stop bit.

[1] = (Default) 1-bit (default)

[2] = 2-bit
Note: For the parameter to take effect, a device reset is required.
Defines the serial communication flow control.

[0] = (Default) None

[1] = Hardware
889
59. Configuration Parameters Reference
Description
Description
Mediant 1000B Gateway and E- SBC