AudioCodes Mediant 1000B User Manual page 263

User's Manual
Note:
The following procedure describes how to configure Time Bands per Cost Group through
the Web interface. You can also configure it through ini file (CostGroupTimebands) or CLI
(configure voip >services least-cost-routing cost-group-time-bands).

To configure a Time Band per Cost Group:
1. Open the Cost Group table (Configuration tab > VoIP menu > Services > Least
Cost Routing > Cost Group Table).
2. Select a Cost Group for which you want to assign Time Bands, and then click the
Time Band link located below the table; the Time Band table for the selected Cost
Group appears.
3. Click Add; the following dialog box appears:
4. Configure a Time Band according to the parameters described in the table below.
5. Click Add, and then save ("burn") your settings to flash memory.
Parameter
Index
timeband-index
[CostGroupTimebands_
TimebandIndex]
Start Time
start-time
[CostGroupTimebands_
StartTime]
End Time
end-time
[CostGroupTimebands_
EndTime]
Version 7.0
You cannot configure overlapping Time Bands.
Table 15-17: Time Band Table Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the day and time of day from when this time band is applicable.
The format is DDD:hh:mm, where:

DDD is the day of the week, represented by the first three letters of
the day in upper case (i.e., SUN, MON, TUE, WED, THU, FRI, or
SAT).

hh and mm denote the time of day, where hh is the hour (00-23) and
mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
Defines the day and time of day until when this time band is applicable.
For a description of the valid values, see the parameter above.
Description
263 Mediant 1000B Gateway and E- SBC
15. Services