AudioCodes Mediant 1000B User Manual page 733

User's Manual
Authorization header (e.g., after receiving a SIP 401 response), it uses the
username and password configured in the Authentication table (see Configuring
Authentication per Port on page 558). To use the username and password
configured in the User Info file, set the 'Password' parameter to any value other
than its default value.
43.1.8.2.1 Configuring GW User Info Table through Web Interface
The following procedure describes how to configure and register users in the GW User Info
table through the Web interface.
Note:
User Info Table in Loadable Text File' on page 735), all previously configured entries
are removed from the table in the Web interface and replaced with the entries from
the loaded User Info file.

To configure the GW User Info table through the Web interface:
1. Open the GW User Info table (Configuration tab > VoIP menu > SIP Definitions >
User Information > GW User Info Table).
2. Click Add; the following dialog box appears:
3. Configure the GW User Info table parameters according to the table below.
4. Click Add.
5. To save the changes to flash memory, see 'Saving Configuration' on page 708.
To register a user, select the user's table entry, and then from the Action button's drop-
down list , choose Register. To un-register a user, select the user, and then from the
Action button's drop-down list , choose Un-Register.
Table 43-2: GW User Info Table Parameter Descriptions
Parameter
Index
[GWUserInfoTable_Index]
Version 7.0
If a User Info file is loaded to the device (as described in 'Configuring GW
Figure 43-3: GW User Info Table - Add Row Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Description
733 Mediant 1000B Gateway and E- SBC
43. Software Upgrade