AudioCodes Mediant 1000B User Manual page 1124

Parameter
sas-indialog-mode
[SASInDialogRequestMod
e]
SAS Inbound
Manipulation Mode
sas-inb-manipul-md
[SASInboundManipulation
Mode]
SAS Registration Manipulation Table
SAS Registration
Manipulation
configure voip >
sas
sasregistrationmani
pulation
[SASRegistrationManipula
tion]
SAS IP-to-IP Routing Table
[IP2IPRouting]
User's Manual
Proxy Set table) and the parameter is set to [1], SAS enters
Emergency mode only if no response is received from sent INVITE or
REGISTER messages.
Defines how the device sends incoming SIP dialog requests received
from users when not in SAS Emergency mode.

[0] = (Default) Send according to the SIP Request-URI.

[1] = Send to Proxy server.
Enables destination number manipulation of incoming INVITE
messages when SAS is in Emergency mode. The manipulation rule is
done in the IP to IP Inbound Manipulation table.

[0] None (default)

[1] Emergency Only
Note: Inbound manipulation applies only to INVITE requests.
Defines the SAS Registration Manipulation table. This table is used by
the SAS application to manipulate the SIP Request-URI user part of
incoming INVITE messages and of incoming REGISTER request AoR
(To header), before saving it to the registered users database. The
format of The table is as follows:
[SASRegistrationManipulation]
FORMAT SASRegistrationManipulation_Index =
SASRegistrationManipulation_RemoveFromRight,
SASRegistrationManipulation_LeaveFromRight;
[\SASRegistrationManipulation]
For example, the manipulation rule below routes an INVITE with
Request-URI header "sip:7184002@10.33.4.226" to user
"4002@10.33.4.226" (i.e., keep only four digits from right of user part):
SASRegistrationManipulation 0 = 0, 4;
Defines the IP-to-IP Routing table for SAS routing rules. The format of
the ini file table parameter is as follows:
[IP2IPRouting]
FORMAT IP2IPRouting_Index = IP2IPRouting_SrcIPGroupName,
IP2IPRouting_SrcUsernamePrefix, IP2IPRouting_SrcHost,
IP2IPRouting_DestUsernamePrefix, IP2IPRouting_DestHost,
IP2IPRouting_DestType, IP2IPRouting_DestIPGroupName,
IP2IPRouting_DestSRDID, IP2IPRouting_DestAddress,
IP2IPRouting_DestPort, IP2IPRouting_DestTransportType,
IP2IPRouting_AltRouteOptions;
[\IP2IPRouting]
For example:
IP2IPRouting 1 = -1, *, *, *, *, 0, -1, -1, , 0, -1, 0;
1124
Mediant 1000B Gateway and E- SBC
Description
Document #: LTRT-27044