Multiple Voip Network Interfaces And Vlan Parameters - AudioCodes Mediant 1000B User Manual

Parameter
Ethernet Group Settings Table
Ethernet Group Settings
configure
voip/ether-group
[EtherGroupTable]
Ethernet Device Table
Ethernet Device Table
[DeviceTable]

59.2.2 Multiple VoIP Network Interfaces and VLAN Parameters

The IP network interfaces and VLAN parameters are described in the table below.
Table 59-10: IP Network Interfaces and VLAN Parameters
Parameter
Interface Table
Interface Table
configure voip >
interface network-
if display
[InterfaceTable]
[EnableNTPasOAM]
User's Manual
For a detailed description of the table, see Configuring Physical
Ethernet Ports on page 127.
Defines the transmit (Tx) and receive (Rx) settings for the Ethernet port
groups. The format of the ini file table parameter is:
[EtherGroupTable]
FORMAT EtherGroupTable_Index = EtherGroupTable_Group,
EtherGroupTable_Mode, EtherGroupTable_Member1,
EtherGroupTable_Member2;
[\EtherGroupTable]
For a detailed description of the table, see Configuring Ethernet Port
Groups on page 129.
Note: For the parameter to take effect, a device reset is required.
Defines Ethernet Devices (VLANs).
The format of the ini file table parameter is as follows:
[ DeviceTable ]
FORMAT DeviceTable_Index = DeviceTable_VlanID,
DeviceTable_UnderlyingInterface, DeviceTable_DeviceName,
DeviceTable_Tagging;
[ \DeviceTable ]
For a detailed description of the table, see Configuring Underlying
Ethernet Devices on page 132.
The table configures the Interface table.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For a detailed description of the table, see 'Configuring IP Network
Interfaces' on page 135.
Defines the application type for Network Time Protocol (NTP) services.

[1] = OAMP (default)
896
Mediant 1000B Gateway and E- SBC
Description
Description
Document #: LTRT-27044