Message Waiting Indication Parameters - AudioCodes Mediant 1000B User Manual

Parameter
Notes:

These parameters are applicable only to FXS interfaces.

For a description of this feature, see Call Forward Reminder Ring on page 523.
Enable NRT
Subscription
nrt-subscription
[EnableNRTSubscriptio
n]
AS Subscribe
IPGroupID
as-subs-ipgroupid
[ASSubscribeIPGroupID
]
NRT Retry Subscription
Time
[NRTSubscribeRetryTi
me]
Call Forward Ring Tone
ID
cfe-ring-tone-id
[CallForwardRingToneI
D]
59.10.5.4

Message Waiting Indication Parameters

The message waiting indication (MWI) parameters are described in the table below.
Parameter
Enable MWI
enable-mwi
[EnableMWI]
MWI Analog Lamp
mwi-analog-lamp
[MWIAnalogLamp]
User's Manual
Enables endpoint subscription for Ring reminder event notification feature.

[0] Disable (default)

[1] Enable
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).
Defines the Retry period (in seconds) for Dialog subscription if a previous
request failed.
The valid value range is 10 to 7200. The default is 120.
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.
Table 59-45: MWI Parameters
Enables Message Waiting Indication (MWI).

[0] Disable (default).

[1] Enable
Notes:

The parameter is applicable only to FXS interfaces.

The device supports only the receipt of SIP MWI NOTIFY messages
(the device doesn't generate these messages).

For more information on MWI, see 'Message Waiting Indication' on
page 526.
Enables the visual display of MWI.

[0] Disable (default).

[1] Enable = Enables visual MWI by supplying line voltage of
approximately 100 VDC to activate the phone's lamp.
Notes:

The parameter is applicable only for FXS interfaces.

The parameter can also be configured in a Tel Profile.
1008
Mediant 1000B Gateway and E- SBC
Description
Description
Document #: LTRT-27044