AudioCodes Mediant 1000B User Manual page 863

User's Manual
Parameter
IP Group
ip-group-id
[Test_Call_IPGroup
Name]
Destination Address
dst-address
[Test_Call_DestAddr
ess]
SIP Interface
sip-interface-
name
[Test_Call_SIPInterf
aceName]
Application Type
application-
type
[Test_Call_Applicatio
nType]
Destination
Transport Type
dst-transport
[Test_Call_DestTran
sportType]
QoE Profile
qoe-profile
[Test_Call_QOEProfi
le]
Bandwidth Profile
bandwidth-
profile
[Test_Call_BWProfil
e]
Version 7.0
parameter in the table.
Notes:

If configured to GW Tel2IP or Dest Address, you must assign a SIP
Interface (see the 'SIP Interface' parameter in the table).

For REGISTER messages:

The GW Tel2IP option cannot be used as the routing method.

If configured to IP Group, only Server-type IP Groups can be used.
Assigns an IP Group to the rule, which is the IP Group that the test call is
sent to or received from.
By default, no value is defined (None).
Notes:

The parameter is applicable only if the 'Route By' parameter is
configured to IP Group [1].

The IP Group is used for incoming and outgoing calls.
Defines the destination host. This can be defined as an IP address[:port] or
DNS name[:port].
Note: The parameter is applicable only if the 'Route By' parameter is
configured to Dest Address [2].
Assigns a SIP Interface to the rule, which is the SIP Interface to which the
test call is sent and received from.
By default, no value is defined (None).
Note: The parameter is applicable only if the 'Route By' parameter is
configured to GW Tel2IP or Dest Address.
Defines the application type for the endpoint. This associates the IP Group
and SRD to a specific SIP interface. For example, assume two SIP
Interfaces are configured in the SIP Interface table where one is set to "GW"
and one to "SBC" for the 'Application Type'. If the parameter is set to "SBC",
the device uses the SIP Interface set to "SBC".

[0] GW (default) = Gateway application

[2] SBC = SBC application
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: The parameter is applicable only if the 'Route By' parameter is set to
[2] (Dest Address).
Assigns a QoE Profile to the test call.
By default, no value is defined (None).
To configure QoE Profiles, see 'Configuring Quality of Experience Profiles'
on page 303.
Assigns a Bandwidth Profile to the test call.
By default, no value is defined (None).
To configure Bandwidth Profiles, see 'Configuring Bandwidth Profiles' on
page 307.
Description
863 Mediant 1000B Gateway and E- SBC
56. Testing SIP Signaling Calls