Configuring Automatic Dialing - AudioCodes Mediant 1000B User Manual

27.5

Configuring Automatic Dialing

The Automatic Dialing table lets you configure telephone numbers that are automatically
dialed when FXS or FXO ports go off-hook. The dialing can be done immediately upon off-
hook, or after a user-defined interval after off-hook referred to as Hotline dialing.
The following procedure describes how to configure automatic dialing upon off-hook
through the Web interface. You can also configure it through ini file (TargetOfChannel) or
CLI (configure voip > gw analoggw automatic-dialing).

To configure automatic dialing per port:
1. Open the Automatic Dialing table (Configuration tab > VoIP menu > Gateway >
Analog Gateway > Automatic Dialing).
2. Click Add; the following dialog box appears:
The figure above shows a configuration example where hotline-automatic dialing is
enabled for an FXS port, whereby if the port is off-hooked for over 15 seconds, the
device automatically dials 911.
3. Configure automatic dialing per port according to the parameters described in the
table below.
4. Click Add.
Table 27-2: Automatic Dialing Table Parameter Descriptions
Parameter
Index
[TargetOfChannel_Index]
Module
[TargetOfChannel_Modul
e]
Port
port
[TargetOfChannel_Port]
Port Type
[TargetOfChannel_PortT
ype]
User's Manual
(Read-only) Displays the index number of the table row.
(Read-only) Displays the module number on which the port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (FXS or FXO).
560
Mediant 1000B Gateway and E- SBC
Description
Document #: LTRT-27044