Routing; Configuring General Routing Parameters; Configuring Tel-To-Ip Routing Rules - AudioCodes Mediant 1000B User Manual

User's Manual
24

Routing

This section describes the configuration of call routing rules.
24.1

Configuring General Routing Parameters

The Routing General Parameters page allows you to configure general routing parameters.
For a description of these parameters, see 'Configuration Parameters Reference' on page
881.

To configure general routing parameters:
1. Open the Routing General Parameters page (Configuration tab > VoIP menu >
Gateway > Routing > General Parameters).
2. Configure the parameters as required.
3. Click Submit.
24.2

Configuring Tel-to-IP Routing Rules

The Tel-to-IP Routing table lets you configure up to 180 Tel-to-IP routing rules. Tel-to-IP
routing rules are used to route calls from the Tel side to an IP destination.
Configuration of Tel-to-IP routing rules includes two areas:

Rule: Defines the characteristics of the incoming Tel call (e.g., Trunk Group on which
the call is received).

Action: Defines the action that is done if the incoming call matches the characteristics
of the rule (i.e., routes the call to the specified IP destination).
The device searches the table from top to bottom for the first rule that matches the
characteristics of the incoming call. If it finds a matching rule, it sends the call to the IP
destination configured for that rule. If it doesn't find a matching rule, it rejects the call.
Version 7.0 483 Mediant 1000B Gateway and E- SBC
24. Routing