Radius Parameters - AudioCodes Mediant 1000B User Manual
Media gateway & enterprise session border controller (e-sbc)
Hide thumbs
Also See for Mediant 1000B:
- User manual (1281 pages) ,
- Hardware installation manual (92 pages) ,
- Configuration note (52 pages)
Table of Contents
Advertisement
User's Manual
Parameter
Default Access Level
default-access-
level
[DefaultAccessLevel]
59.14.1.2
RADIUS Parameters
The RADIUS parameters are described in the table below.
Parameter
General RADIUS Parameters
Enable RADIUS Access
Control
enable
[EnableRADIUS]
[RadiusTrafficType]
RADIUS VSA Vendor ID
configure system >
radius > vsa-
vendor-id
[RadiusVSAVendorID]
[MaxRADIUSSessions]
RADIUS Packets
Retransmission
[RADIUSRetransmission]
RADIUS Response Time
Out
[RadiusTO]
RADIUS Accounting Parameters
RADIUS Accounting Type
Version 7.0
Defines the default access level for the device when the LDAP/RADIUS
response doesn't include an access level attribute for determining the
user's management access level.
The valid range is 0 to 255. The default is 200 (i.e., Security
Administrator).
Note: The parameter is applicable to LDAP- or RADIUS-based
management-user login authentication and authorization.
Table 59-76: RADIUS Parameters
Enables the RADIUS application.
[0] Disable (Default)
[1] Enable
Note: For the parameter to take effect, a device reset is required.
Defines the device's network interface for communicating (RADIUS
traffic) with the RADIUS server(s).
[0] OAMP (default)
[1] Control
Note: If set to Control, only one Control interface must be configured in
the Interface table; otherwise, RADIUS communication will fail.
Defines the vendor ID that the device accepts when parsing a RADIUS
response packet.
The valid range is 0 to 0xFFFFFFFF. The default is 5003.
Defines the number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
Defines the number of RADIUS retransmission retries when no
response is received from the RADIUS server. See also the RadiusTo
parameter.
The valid range is 1 to 10. The default is 3.
Defines the time interval (in seconds) that the device waits for a
response before it performs a RADIUS retransmission. See also the
RADIUSRetransmission parameter.
The valid range is 1 to 30. The default is 10.
Determines when the RADIUS accounting messages are sent to the
RADIUS accounting server.
1131
59. Configuration Parameters Reference
Description
Description
Mediant 1000B Gateway and E- SBC
Advertisement
Table of Contents
