AudioCodes Mediant 1000B User Manual page 765

User's Manual
"Voice", 80.179.52.100, 0.0.0.0, "vlan 1";
[ \InterfaceTable ]
•
CLI:
# configure voip
(config-voip)# interface network-if 0
(network-if-0)# primary-dns 80.179.52.100
3. Configure the device with the following Automatic Update settings:
a. Automatic Update is done every 24 hours (1440 minutes):
♦
♦
b. Automatic Update of software file (.cmp):
♦
♦
c. Automatic Update of Call Progress Tone file:
♦
♦
d. Automatic Update of ini configuration file:
♦
♦
e. Enable Cyclical Redundancy Check (CRC) on downloaded ini file:
♦
♦
4. Power down and then power up the device.
Version 7.0
ini File:
AutoUpdateFrequency = 1440
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# update-frequency 1440
ini File:
AutoCmpFileUrl =
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# auto-firmware 'http://www.company.com/sw.cmp'
ini File:
CptFileURL =
'https://www.company.com/call_progress.dat'
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# call-progress-tones
'http://www.company.com/call_progress.dat'
ini File:
IniFileURL = 'https://www.company.com/config.ini'
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# voice-configuration
'http://www.company.com/config.ini'
ini File:
AUPDCheckIfIniChanged = 1
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# crc-check regular
'https://www.company.com/sw.cmp'
765 Mediant 1000B Gateway and E- SBC
44. Automatic Provisioning