AudioCodes Mediant 1000B User Manual page 934

Parameter
Registrar Parameters
Enable Registration
enable-registration
[IsRegisterNeeded]
Registrar Name
registrar-name
[RegistrarName]
Registrar IP Address
ip-addrr-rgstrr
[RegistrarIP]
Registrar Transport Type
registrar-transport
[RegistrarTransportType]
Registration Time
registration-time
[RegistrationTime]
User's Manual
Enables the device to register to a Proxy/Registrar server.

[0] Disable = (Default) The device doesn't register to Proxy/Registrar
server.

[1] Enable = The device registers to Proxy/Registrar server when the
device is powered up and at every user-defined interval (configured
by the parameter RegistrationTime).
Notes:

The parameter is applicable only to the Gateway application.

The device sends a REGISTER request for each channel or for the
entire device (according to the AuthenticationMode parameter).
Defines the Registrar domain name. If specified, the name is used as
the Request-URI in REGISTER messages. If it isn't specified (default),
the Registrar IP address, or Proxy name or IP address is used instead.
The valid range is up to 100 characters.
Note: The parameter is applicable only to the Gateway application.
Defines the IP address (or FQDN) and port number (optional) of the
Registrar server. The IP address is in dotted-decimal notation, e.g.,
201.10.8.1:<5080>.
Notes:

The parameter is applicable only to the Gateway application.

If not specified, the REGISTER request is sent to the primary Proxy
server.

When a port number is specified, DNS NAPTR/SRV queries aren't
performed, even if the parameter DNSQueryType is set to 1 or 2.

If the parameter RegistrarIP is set to an FQDN and is resolved to
multiple addresses, the device also provides real-time switching
(hotswap mode) between different Registrar IP addresses (the
parameter IsProxyHotSwap is set to 1). If the first Registrar doesn't
respond to the REGISTER message, the same REGISTER message
is sent immediately to the next Proxy. To allow this mechanism, the
parameter EnableProxyKeepAlive must be set to 0.

When a specific transport type is defined using the parameter
RegistrarTransportType, a DNS NAPTR query is not performed even
if the parameter DNSQueryType is set to 2.
Determines the transport layer used for outgoing SIP dialogs initiated by
the device to the Registrar.

[-1] Not Configured (default)

[0] UDP

[1] TCP

[2] TLS
Notes:

The parameter is applicable only to the Gateway application.

When set to 'Not Configured', the value of the parameter
SIPTransportType is used.
Defines the time interval (in seconds) for registering to a Proxy server.
The value is used in the SIP Expires header. The parameter also
defines the time interval between Keep-Alive messages when the
parameter EnableProxyKeepAlive is set to 2 (REGISTER).
934
Mediant 1000B Gateway and E- SBC
Description
Document #: LTRT-27044