Assigning Cost Groups To Routing Rules - AudioCodes Mediant 1000B User Manual

Parameter
Connection Cost
connection-cost
[CostGroupTimebands_
ConnectionCost]
Minute Cost
minute-cost
[CostGroupTimebands_
MinuteCost]

15.4.2.3 Assigning Cost Groups to Routing Rules

To use your configured Cost Groups, you need to assign them to routing rules:

Gateway application: Tel-to-IP Routing table - see Configuring Tel-to-IP Routing Rules
on page 483

SBC application: IP-to-IP Routing table - see Configuring SBC IP-to-IP Routing Rules
on page 643
User's Manual
Defines the call connection cost during this time band. This is added as a
fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a decimal).
Defines the call cost per minute charge during this timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a decimal).
264
Mediant 1000B Gateway and E- SBC
Description
Document #: LTRT-27044