Resource Allocation Indication Parameters - AudioCodes Mediant 1000B User Manual

Parameter
Logging Filters Table
configure system >
logging > logging-
filters
[LoggingFilters]
Gateway CDR Format Table
Gateway CDR Format
Table
configure voip >
services cdr > cdr-
format gw-cdr-
format
[GWCDRFormat]
SBC CDR Format Table
SBC CDR Format Table
configure voip >
services cdr > cdr-
format sbc-cdr-
format
[SBCCDRFormat]

59.3.4 Resource Allocation Indication Parameters

The Resource Allocation Indication (RAI) parameters are described in the table below.
Parameter
[EnableRAI]
User's Manual
The table defines logging filtering rules for Syslog messages and debug
recordings.
The format of the ini file table parameter is:
[ LoggingFilters ]
FORMAT LoggingFilters_Index = LoggingFilters_FilterType,
LoggingFilters_Value, LoggingFilters_LogDestination,
LoggingFilters_CaptureType, LoggingFilters_Mode;
[ \LoggingFilters ]
For a detailed description of the table, see 'Configuring Log Filter Rules'
on page 839.
The table defines CDR customization rules for Gateway calls. .
The format of the ini file table parameter is:
[ GWCDRFormat ]
FORMAT GWCDRFormat_Index = GWCDRFormat_CDRType,
GWCDRFormat_ColumnType, GWCDRFormat_Title,
GWCDRFormat_RadiusType, GWCDRFormat_RadiusID;
[ \GWCDRFormat ]
For a detailed description of the table, see Customizing CDRs for
Gateway Calls on page 818.
The table defines CDR customization rules for SBC calls.
The format of the ini file table parameter is:
[ SBCCDRFormat ]
FORMAT SBCCDRFormat_Index = SBCCDRFormat_CDRType,
SBCCDRFormat_ColumnType, SBCCDRFormat_Title,
SBCCDRFormat_RadiusType, SBCCDRFormat_RadiusID;
[ \SBCCDRFormat ]
For a detailed description of the table, see Customizing CDRs for SBC
Calls on page 821.
Table 59-21: RAI Parameters
Enables Resource Available Indication (RAI) alarm generation if the
device's busy endpoints exceed a user-defined threshold, configured by
the RAIHighThreshold parameter. When enabled and the threshold is
crossed, the device sends the SNMP trap,
acBoardCallResourcesAlarm.

[0] = (Default) Disable

[1] = Enable
Note: For the parameter to take effect, a device reset is required.
914
Mediant 1000B Gateway and E- SBC
Description
Description
Document #: LTRT-27044