Test Call Configuration Examples - AudioCodes Mediant 1000B User Manual

Parameters' on page 907):
a. Open the Test Call Settings page (Configuration tab > System menu > Test
Call > Test Call Settings).
b. In the 'Test Call ID' field, enter a prefix number for the simulated test endpoint on
the device.
c. In the 'SBC Test ID' field, enter a called prefix number for identifying the call as
an SBC test call.
d. Click Submit.
2. Configure regular SBC call processing rules for called number prefix "101", such as
classification and IP-to-IP routing through a proxy server.
56.7

Test Call Configuration Examples

Below are a few examples of test call configurations.

Single Test Call Scenario: This example describes the configuration of a simple test
call scenario that includes a single test call between a simulated test endpoint on the
device and a remote endpoint.
•
Test Call table configuration:
♦
♦
♦
♦
♦
♦
♦
Alternatively, if you want to route the test call using the Tel-to-IP Routing table for the
Gateway application, configure the following:
•
Test Call table configuration:
♦
♦
♦
♦
User's Manual
Figure 56-7: Test Call Settings Page
Figure 56-8: Single Test Call Example
Endpoint URI: "101"
Called URI: "201"
Route By: Dest Address
Destination Address: "10.30.40.01"
SIP Interface: SIPInterface_0
Call Party: Caller
Test Mode: Once
Endpoint URI: 101@10.0.0.1
Route By: GW Tel2IP
SIP Interface: SIPInterface_0
Called URI: 201@10.30.40.1
Mediant 1000B Gateway and E- SBC
870 Document #: LTRT-27044