AudioCodes Mediant 1000B User Manual page 1132

Parameter
radius-accounting
[RADIUSAccountingType]
AAA Indications
aaa-indications
[AAAIndications]
RADIUS User Authentication Parameters
Use RADIUS for
Web/Telnet Login
enable-mgmt-login
[WebRADIUSLogin]
Password Local Cache
Mode
local-cache-mode
[RadiusLocalCacheMode]
Password Local Cache
Timeout
local-cache-timeout
[RadiusLocalCacheTimeo
ut]
RADIUS VSA Access
Level Attribute
vsa-access-level
[RadiusVSAAccessAttribu
te]
User's Manual

[0] At Call Release = (Default) Sent at call release only.

[1] At Connect & Release = Sent at call connect and release.

[2] At Setup & Release = Sent at call setup and release.
Determines the Authentication, Authorization and Accounting (AAA)
indications.

[0] None = (Default) No indications.

[3] Accounting Only = Only accounting indications are used.
Enables RADIUS queries for Web and Telnet login authentication.
When enabled, logging into the device's Web and Telnet embedded
servers is done through a RADIUS server. The device communicates
with a user-defined RADIUS server and verifies the given username
and password against a remote database, in a secure manner.

[0] Disable (default)

[1] Enable
Notes:

For RADIUS login authentication to function, you must also
configure the EnableRADIUS parameter to 1 (Enable).

RADIUS authentication requires HTTP basic authentication, where
the username and password are transmitted in clear text over the
network. Therefore, it's recommended to set the HTTPSOnly
parameter to 1 to force the use of HTTPS, since the transport is
encrypted.
Defines the device's mode of operation regarding the timer (configured
by the parameter RadiusLocalCacheTimeout) that determines the
validity of the username and password (verified by the RADIUS
server).

[0] Absolute Expiry Timer = When you access a Web page, the
timeout doesn't reset, instead it continues decreasing.

[1] Reset Timer Upon Access = (Default) Upon each access to a
Web page, the timeout always resets (reverts to the initial value
configured by RadiusLocalCacheTimeout).
Defines the time (in seconds) the locally stored username and
password (verified by the RADIUS server) are valid. When this time
expires, the username and password become invalid and a must be re-
verified with the RADIUS server.
The valid range is 1 to 0xFFFFFF. The default is 300 (5 minutes).

[-1] = Never expires.

[0] = Each request requires RADIUS authentication.
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default is 35.
1132
Mediant 1000B Gateway and E- SBC
Description
Document #: LTRT-27044