Syslog, Cdr And Debug Parameters - AudioCodes Mediant 1000B User Manual

Parameter
SBC Test ID
sbc-test-id
[SBCtestID]
Test Call Table
Test Call Table
configure system >
test-call > test-
call-table
[Test_Call]

59.3.3 Syslog, CDR and Debug Parameters

The Syslog, CDR and debug parameters are described in the table below.
Parameter
Enable Syslog
syslog
[EnableSyslog]
User's Manual
Defines the SBC test call prefix (ID) for identifying SBC test calls that
traverse the device to register with an external routing entity such as
an IP PBX or proxy server.
The parameter functions together with the TestCallID parameter, which
defines the prefix of the simulated endpoint. Upon receiving an
incoming call with this prefix, the device removes the prefix, enabling it
to forward the test call to the external entity. Upon receiving the call
from the external entity, the device identifies the call as a test call
according to its prefix, defined by the TestCallID, and then sends the
call to the simulated endpoint.
For example, assume SBCTestID is set to 4 and TestCallID to 2. If a
call is received with called destination 4200, the device removes the
prefix 4 and routes the call to the IP PBX. When it receives the call
from the IP PBX, it identifies the call as a test call (i.e., prefix 2) and
therefore, sends it to the simulated endpoint.
The valid value can be any string of up to 15 characters. By default, no
number is defined.
Note: This feature is applicable only to the SBC application.
Defines Test Call rules.
[ Test_Call ]
FORMAT Test_Call_Index = Test_Call_EndpointURI,
Test_Call_CalledURI, Test_Call_RouteBy, Test_Call_IPGroupName,
Test_Call_DestAddress, Test_Call_DestTransportType,
Test_Call_SIPInterfaceName, Test_Call_ApplicationType,
Test_Call_AutoRegister, Test_Call_UserName, Test_Call_Password,
Test_Call_CallParty, Test_Call_MaxChannels, Test_Call_CallDuration,
Test_Call_CallsPerSecond, Test_Call_TestMode,
Test_Call_TestDuration, Test_Call_Play, Test_Call_ScheduleInterval,
Test_Call_QOEProfile, Test_Call_BWProfile;
[ \Test_Call ]
For a description of the table, see 'Configuring Test Call Endpoints' on
page 861.
Table 59-20: Syslog, CDR and Debug Parameters
Determines whether the device sends logs and error messages (e.g.,
CDRs) generated by the device to a Syslog server.

[0] Disable (default)

[1] Enable
Notes:

If you enable Syslog, you must enter an IP address of the Syslog
server (using the SyslogServerIP parameter).

Syslog messages may increase the network traffic.

To configure Syslog SIP message logging levels, use the
Mediant 1000B Gateway and E- SBC
Description
Description
908 Document #: LTRT-27044