Upgrade Kit
Nitrogen Phosphorus Detector
About This Guide
It provides the instructions to install and configure the Nitrogen Phosphorus on
your TRACE GC Ultra.
NOTE
For Conventions, Symbols and Costumer Communications, please refer to the TRACE GC
Ultra Operating Manual.
Introduction
The upgrade kit contains all the material required to install the Nitrogen
Phosphorus Detector on your TRACE GC Ultra:
•
•
•
•
CAUTION
The detector gas control module is not part of this kit.
Who Performs the Installation of the Kit
If, for any reason, the kit is not installed by Thermo Fisher Scientific technical
personnel, you must carefully adhere to the following instructions.
Detector Gases Requirements
The NPD requires air and hydrogen as fuel gases and nitrogen or helium as make-
up gas. Make-up gas is not necessary when packed column is used.
According to the required gases, the DGFC or the Non-DGFC module is:
•
6
NPD Assembly for TRACE
NPD Control Card
Transformer for NPD
NPD Standard Outfit
Type AD for the control of air, hydrogen and make-up gas.
About This Guide
Installation Guide