Splicecom S8000/718 Installation & Maintenance Manual page 8

Installation and Maintenance Manual
will be enabled. All this configuration can be re-configured afterwards however you may wish to
save yourself time by determining which of these scenarios you require before you boot up the Call
Server. (Please refer to the
Setting DHCP section from page 12 for further details.)
When a standalone 5100/5108 Call Server is powered up it will become a Primary Call Server. All
subsequent Call Servers connected to the initial Call Server will become secondary call servers.
Ensure that you install the Call Server you wish to be the Primary first. If a Call Server is connected to
a network during power up and it detects that another Call Server exists on the network it will
attempt to join this system. Ensure the Call Server is disconnected from the network during power
up if this is not required. (Please refer to Connecting Multiple Call Servers from page 83 for further
details.)
5100 Call Server – Front and Rear view
5108 Call Server – Front and Rear view
4
Installing a System
Installation and Maintenance Manual v4/0615/10