Splicecom S8000/718 Installation & Maintenance Manual page 65

Installation and Maintenance Manual
A list of the IP Addresses for each PCS
410/400/100 can be viewed in Manager Assist
by selecting System Utilities and then IP
Addresses.
Setting the IP Address
When connecting a PCS 410/400/100 to the system for the first time a DHCP server is required to give the
PCS an IP address. This address can be viewed as described above. However once connected the PCS
410/400/100 can be given a static address as follows:
1 Within the Command prompt enter
telnet <ip address of PCS 410/400/100> eg telnet 192.168.0.250
2 You will be prompted for a Username, enter diag
3 You will be prompted for the password for this IP phone. By default this is 7388. (Please refer to
the Setting the Password section from page 60 for further details.)
4 Wait for a # to appear to confirm a connection has been made to the PCS
5 Enter setnet
6 The current configuration will be displayed. You will be asked if you wish to change any of this
configuration.
7 Enter y
8 You will be asked how the IP address will be assigned.
9 Delete the d and enter s
10 Follow the onscreen prompts entering the IP address you wish to give the PCS, eg 192.168.0.50,
the netmask you wish to use, eg 255.255.255.0, the IP address of the Gateway (Default Router), eg
192.168.0.1 and the IP address of the TFTP server which will be the IP address of the Call Server to
provide software to the PCS during an upgrade, eg 192.168.0.1.
11 At any other prompt make the changes you require otherwise press Enter to leave the option
unchanged.
12 You will be asked if you wish to save the changes. Enter y.
13 Telnet will display that the changes are being saved.
14 When finished enter poweroff and the PCS will reboot
Please note:
If a PCS 410, 400 or 100 has been given an IP address already being used on the network a warning
message will be displayed on the screen.
To return to using DHCP follow the same instructions above. Enter
will be assigned.
At any prompt you may enter a ? for help on that option or q to quit.
For further information on working with Telnet please refer to page 300.
Setnet can be used to set the Time Zone to be used by a specific IP phone
System Configuration
Installation and Maintenance Manual v4/0615/10
d
when asked how the IP address
61