Splicecom S8000/718 Installation & Maintenance Manual page 59

Maximiser
Table of Contents

Advertisement

Installation and Maintenance Manual
2
In the Phones Base Address: field enter the IP address of the handset (if you wish to configure
more than one enter the first IP address of the range and then the last part of the IP address of the
last IP address in the range, eg 192.168.0.53-58.
3
In the Static Base Address field enter the IP address to be given to the handset.
4
In the remaining fields enter the network configuration required.
5
Ensure the Reboot Phone: field is set to Yes.
6
Select Submit when ready.
7
The handset(s) will reboot and will now be using the above configuration.
8
The WebSetnet page will display the values that were submitted to the handset(s).
Please note:
If you wish to remove an existing entry from the phones configuration and not replace it, tick the
Unset check box for the relevant field. After submitting the changes you will receive a warning of
this, select OK if you wish to continue.
Some fields will appear to contain entries (these just give examples) however if you click in the
boxes they will be empty. Only data that you physical enter into these fields will be set on the
handset.
To return a handset(s) to using DHCP, enter the handset(s) IP address and then tick the Unset
checkbox beside Static Base Address, and tick any other field that was set such as NetMask Address,
Gateway Address: and so on.
System Configuration
Installation and Maintenance Manual v4/0615/10
In this example,
these fields show
the sample
entries but will
not be changed
on the actual
55

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S8000/718 and is the answer not in the manual?

This manual is also suitable for:

4100510041405108

Table of Contents