Splicecom S8000/718 Installation & Maintenance Manual page 36

Installation and Maintenance Manual
Changing the Password
When accessing the configuration web pages for an I208/I230 as described below, the module's
password is entered on connection. When accessing the I208/I230 via a ssh terminal window the login
name is diag and then the password for the module is entered. By default this password is set to 7388.
However this password can be changed as follows:
1 In Manager select Modules
2 Select the I208/I230 required
3 Select the Trunk Module page
4 In the Password field enter the password required
5 Select Update or Apply when ready.
6 Reboot the I208/I230 via the Reset switch or a ssh terminal window
Setting the IP address and Network configuration
The network configuration of the I208/I230 can be set by accessing the configuration web page as
follows:
1. Within any browser enter the IP address of the I208/I230, eg 192.168.0.46
2. Within the Password: field enter the password for the I208/I230. By default this will be 7388 (the
password is set within the relevant I208/I230's configuration form as described above).
3. Select the Login button.
4. The network configuration of the I208/I230 will be displayed with the module type and its hardware
address, together with loader and software version being used by the unit.
32
System Configuration
Installation and Maintenance Manual v4/0615/10