Splicecom S8000/718 Installation & Maintenance Manual page 51

Installation and Maintenance Manual
Each port on the Phone Module can now be configured independently, see page 89 for further details.
Changing the Password
When accessing a Phone Module via Telnet, when upgrading for example, the module's password is
entered on connection. By default this is set to 7388. However this password can be changed as follows:
1 In Manager select Modules
2 Select the Phone Module required
3 Select the Phone Module page
4 In the Password field enter the password required
5 Select Update or Apply when ready.
6 Reboot the Phone Module
Setting the IP Address and network configuration
When connecting a Phone Module to the system for the first time a DHCP server is required to give the
Phone Module an IP address. This address can be viewed within the Phone Module's configuration form
as described on page 46. However once connected the Phone Module can be given a static address as
follows:
1 Within a Command prompt enter
telnet <ip address of Phone Module>
then press Enter
2 You will be prompted for a Username, enter diag, then press Enter
3 You will be prompted for the password for this Phone Module. By default this is 7388. (The
Password is set within the relevant Phone Module's configuration form.) Then press Enter.
4 Wait for a # to appear to confirm a connection has been made to the Phone Module
System Configuration
Installation and Maintenance Manual v4/0615/10
eg telnet 192.168.0.250
47