Setting Up Administrative Access - Splicecom S8000/718 Installation & Maintenance Manual

Installation and Maintenance Manual
Please note:
The system will take into account British Summer Time.
If multiply Call Servers are being used on one system the above time will be the time used by the
Call Server whose Manager is being viewed. Each Call Server can have a different date and time.
This information will be sent and updated on all handsets registered to the specific Call Server.
On a S8000/S716 the time must be obtained via an NTP server.
A Time Zone can be set when the time displayed in, for example, call logging information needs to be
identified with its Time Zone. This is useful when, for example, one maximiser system with multiple Call
Servers is working across multiple countries or states and the time of a call needs to be identified with its
correct Time Zone. (For further information on working with multiple Call Servers please refer to page
83.)
Each Call Server can have a different Time Zone and is configured as follows:
1 Open Manager on the Call Server to be configured
2 Within Manager Assist, select System Utilities and then Set Time
3 From the Time Zone list box select the option required
4 Select Update when ready.
5 Reboot the Call Server (please refer to page 283 for further information)
Please note: Setnet can be used to set the time zone for a specific Phone Module. For further
information please refer to the Using Setnet section from page 299.

Setting up Administrative Access

Default Administrator
By default administration access to the database via Manager is available by logging in as "Manager"
using the password "managerpassword". This Administrator has full access to the database. For security,
it is advisable to at least change the password for this Administrator once access has been achieved.
1 In Manager, select Administrators
2 The Administrator List will be displayed
3 Select Manager
4 In the Password field enter the password required. Alpha-numeric characters only.
5 Select Update or Apply when ready
Please note: This default Administrator, Manager, gives Authorised Access to new Administrators as
described below. It is therefore recommended that Manager is not deleted.
14
System Configuration
Installation and Maintenance Manual v4/0615/10