Splicecom S8000/718 Installation & Maintenance Manual page 362

Maximiser
Table of Contents

Advertisement

Installation and Maintenance Manual
Account Name In
Name presented from distant end to be checked with password for access authentication.
Account Password In
Password presented from distant end to be checked with name for access authentication.
Telephone Number
ISDN number to dial to reach the distant end. This field is only required at the end that makes the call.
DDI Telephone Number
Blank
No ISDN access into this unit
*
ISDN access allowed via any data call on any ISDN port
Any number
ISDN access allowed when matched to this DDI on any ISDN port
Time Plan
The name (GUID) of the Time Plan that will determine the operational hours of the link, if left blank the
link will work 24x7
Dial Usage Quota
Not used
IP Header Compression
IP headers within PPP will be compressed.
Caller IDs
This link will only answer if the call originates from one of the CLIs listed here.
Trunks
Trunks on this module on which outgoing calls will be made. Please note: Data calls are not routed via
Dial Plan entries or LCR Plan entries so enter any required prefixes in the Telephone Number field.
IP Routes page
IP Address
The TCP/IP address of the distant network or host
IP Mask
The subnet mask for the IP Address above
IP Gateway
Gateway to be used
Metric
A value from 0 to 15 where 0 is the best value. If in doubt set it as 1, equates to values in RIP.
PPP page
Multilink
Enable/Disable. Enables the negotiation of Multilink. Some products abandon a call/link if asked to
negotiate. Typically set to Enable
358
Field Descriptions
Installation and Maintenance Manual v4/0615/10

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S8000/718 and is the answer not in the manual?

This manual is also suitable for:

4100510041405108

Table of Contents