Overview - Motorola DSP56009 User Manual

Serial Host Interface
Characteristics Of The I
5.5 CHARACTERISTICS OF THE I
2
The I C serial bus consists of two bi-directional lines, one for data signals (SDA) and
one for clock signals (SCL). Both the SDA and SCL lines must be connected to a
positive supply voltage via a pull-up resistor.
2
Note: Within the I
high-speed mode (100 kHz clock rate) are defined. The SHI operates in the
high-speed mode only.
5.5.1

Overview

2
The I C bus protocol must conform to the following rules:
• Data transfer may be initiated only when the bus is not busy.
• During data transfer, the data line must remain stable whenever the clock line
is high. Changes in the data line when the clock line is high will be interpreted
as control signals (see Figure 5-7).
SDA
SCL
5-20
2
C Bus
C bus specifications, a low-speed mode (2 kHz clock rate) and a
Data Line
Stable:
Data Valid
Figure 5-7 I
DSP56009 User's Manual
2
C BUS
Change
of Data
Allowed
2
C Bit Transfer
AA0422
MOTOROLA