Table of Contents
Advertisement
28
599
•
Router—Specifies if the neighbor is a Router. A hyphen (-) is displayed for
static entries.
28.34 show ipv6 route
Use the show ipv6 route command in user EXEC or privileged EXEC mode to
display the current contents of the IPv6 routing table.
Syntax
ipv6-address
show ipv6 route [
interface-id
]
Parameters
•
ipv6-address
—Displays routing information for a specific IPv6 address.
This argument must be in the form documented in RFC4293 where the
address is specified in hexadecimal using 16-bit values between colons.
•
ipv6-prefix
—Displays routing information for a specific IPv6 network. This
argument must be in the form documented in RFC4293 where the address
is specified in hexadecimal using 16-bit values between colons.
•
prefix-length
/
—The length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.
•
protocol—Displays routes for the specified routing protocol using any of
these keywords: bgp, isis, ospf, or rip; or displays routes for the specified
type of route using any of these keywords: connected, static, nd, or icmp.
•
interface-id
interface
Default Configuration
All IPv6 routing information for all active routing tables is displayed.
Command Mode
User EXEC mode
Privileged EXEC mode
ipv6-prefix/prefix-length
|
—Identifier of an interface.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 Commands
protocol
|
| interface
Advertisement
Table of Contents
