Span And Rspan Commands; Monitor Session Destination - Cisco Sx350 Cli Manual

SPAN and RSPAN Commands

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
57.0

57.1 monitor session destination

To create a new Switched Port Analyzer (SPAN) or Remote SPAN (RSPAN)
destination session, use the monitor session destination command in Global
Configuration mode. To remove a destination session, use the no form of the
command.
Syntax
session_number
monitor session
vlan-id
{remote vlan reflector-port
session_number
no monitor session
Parameters
•
session_number
RSPAN or flow mirror session. The range is 1 to 7.
•
interface-id
interface
RSPAN or flow mirror session (Ethernet port). When the source interface is a
RSPAN VLAN the RSPAN VLAN_ID is removed from all frames copied to the
interface.
•
network—Specify that the destination port acts also as a network port.
•
vlan-id
remote vlan
session. Not more than one RSPAN destination VLAN can be defined. The
VLAN must be defined as a RSPAN transit VLAN in the source, intermediate
and final switches by the
•
reflector-port
session (Ethernet port). The RSPAN VLAN_ID is added to all frames copied
to the interface.
destination {{interface
interface-id
destination
—Specify the session number identified with the SPAN,
—Specify the destination interface for the SPAN,
—Specify the RSPAN VLAN for an RSPAN destination
remote-span
interface-id
—Specify the destination interface for a RSPAN
57
interface-id
} network}
command.
[network]} |
1088