Table of Contents
Advertisement
67
1261
Use this command to isolate Unicast, Multicast, and Broadcast traffic at Layer 2
from other protected ports (that are not associated with the same community as
the ingress interface) on the same switch. Please note that the packet is still
subject to FDB decision and to all filtering rules.
Example
switchxxxxxx(config)#
switchxxxxxx(config-if)#
67.8 show interfaces protected-ports
Use the show interfaces protected-ports EXEC mode command to display
protected ports configuration.
Syntax
show interfaces protected-ports [
Parameters
•
interface-id
—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or port-channel.
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Show all protected interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
User EXEC mode
Example
switchxxxxxx#
show interfaces protected-ports
Virtual Local Area Network (VLAN) Commands
interface gi11
switchport protected-port
interface-id
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
| detailed]
Advertisement
Table of Contents
