Cisco Sx350 Cli Manual page 870

Hide thumbs Also See for Sx350:

Table of Contents

Network Management Protocol (SNMP) Commands

Command Mode

Global Configuration mode

User Guidelines

For SNMP v1 and v2, this command performs the same actions as snmp-server

community-group, except that snmp-server community-group configures both v1 and v2 at the

same time. With this command, you must perform it once for v1 and once for v2.

When you enter the show running-config command, you do not see a line for the

SNMP user defined by this command. To see if this user has been added to the

configuration, type the show snmp user command.

A local SNMP EngineID must be defined in order to add SNMPv3 users to the

device (use the

snmp-server engineID remote

command). For remote hosts users

a remote SNMP EngineID is also required (use the

snmp-server engineID remote

Changing or removing the value of snmpEngineID deletes the SNMPv3 users'

The logical key of the command is username.

Configuring a remote host is required in order to send informs to that host,

because an inform is a trap that requires acknowledgement. A configured remote

host is also able to manage the device (besides getting the informs)

To configure a remote user, specify the IP address for the remote SNMP agent of

the device where the user resides. Also, before you configure remote users for a

particular agent, configure the SNMP engine ID, using the

snmp-server engineID

command. The remote agent's SNMP engine ID is needed when

computing the authentication and privacy digests from the password. If the

remote engine ID is not configured first, the configuration command fails.

Since the same group may be defined several times, each time with different version or

different access level (noauth, auth or auth & priv), when defining a user it is not sufficient to

specify the group name, rather you must specify group name, version and access level for

complete determination of how to handle packets from this user.

This example assigns user

using SNMP v1 and v2c. The default

is assigned as the engineID. User

is assigned to group

using SNMP v1

switchxxxxxx(config)#

snmp-server user tom acbd v1

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide