Table of Contents
Advertisement
55
1069
User Guidelines
A static type set by the command cannot be changed by a dynamic type.
Example
This example shows an attempt to set the Smartport type of port 1 to printer
(statically). The macro fails at line 10. The
display the contents of the macro printer in order to see which line failed.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
30-May-2011 15:02:45 %AUTOSMARTPORT-E-FAILEDMACRO: Macro printer for auto smar
port type Printer on interface gi11 failed at command number 10
switchxxxxxx(config-if)#
switchxxxxxx(config)#
Macro name : printer
Macro type : default interface
1. #macro description printer
2. #macro keywords $native_vlan
3. #
4. #macro key description:
red on the port
5. #Default Values are
6. #$native_vlan = Default VLAN
7. #
8. #the port type cannot be detected automatically
9. #
10. switchport mode access
11. switchport access vlan $native_vlan
12. #
13. #single host
14. port security max 1
15. port security mode max-addresses
show parser macro
interface gi11
macro auto smartport type printer
exit
do show parser macro name printer
$native_vlan: The untag VLAN which will be configu
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Smartport Commands
command is run to
Advertisement
Table of Contents
