Cisco Sx350 Cli Manual page 529

IP Routing Protocol-Independent Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Status: Active
ACL Name: ACLTCPHTTP
Next Hop: 1.1.1.20
Next Hop Status: Active
IP Routing Table - 4 entries
Code IP Route Distance/ Next Hop
Metric
------ ------------------- ----------- ---------------
S> 10.175.0.0/16 1/1
S> 10.180.0.0/16 1/1
C> 10.119.0.0/16 0/1
C> 10.120.0.0/16 0/1
Example 3. In the following example, the logical AND operation is performed on
the address 10.16.0.0 and the mask 255.255.0.0, resulting in 10.16.0.0. On each
destination in the routing table the logical AND operation is also performed with
the mask and the result is compared with 10.16.0.0. Any destinations that fall into
that range are displayed in the output:
show ip route 10.16.0.0 255.255.0.0 longer-prefix
switchxxxxxx#
Maximum Parallel Paths: 1 (1 after reset)
IP Forwarding: enabled
Directed Broadcast Forwarding: disabled
Codes: > - best, C - connected, S - static
Policy Routing
VLAN 1
Route Map: BPR1
Status: Active
ACL Name: ACLTCPHTTP
Next Hop: 1.1.1.1
Next Hop Status: Active
ACL Name: ACLTCPTELNET
Next Hop: 2.2.2.2
Last Time Outgoing
IP Address Updated Interface
------------- ------------
10.119.254.240 00:02:22
10.119.254.240 00:02:42
0.0.0.0
0.0.0.0
vlan2
vlan3
vlan2
vlan3
25
528