Cisco Sx350 Cli Manual page 359

DHCPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Use the no form of the command without arguments to remove all the defined
addresses and to disable the relay on the interface.
Examples
Example 1. The following example sets the relay Unicast link-local destination
address per VLAN 200 and enables the DHCPv6 Relay on VLAN 100 if it was not
enabled:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 2. The following example sets the relay well known Multicast link-local
destination address per VLAN 200 and enables the DHCPv6 Relay on VLAN 100 if
it was not enabled:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 3. The following example sets the Unicast global relay destination
address and enables the DHCPv6 Relay on VLAN 100 if it was not enabled:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
Example 4. The following example enables DHCPv6 relay on VLAN 100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
interface vlan 100
ipv6 dhcp relay destination FE80::1:2 vlan 200
exit
interface vlan 100
ipv6 dhcp relay destination vlan 200
exit
interface vlan 100
ipv6 dhcp relay destination 3002::1:2
exit
interface vlan 100
ipv6 dhcp relay destination
14
358