Ipv6 Mld Snooping Querier - Cisco Sx350 Cli Manual

42
MLD Snooping Commands
Syntax
vlan-id
ipv6 mld snooping vlan
vlan-id
no ipv6 mld snooping vlan
Parameters
•
vlan-id
—Specifies the VLAN.
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
MLD snooping can only be enabled on static VLANs.
MLDv1 and MLDv2 are supported.
To activate MLD snooping, bridge multicast filtering must be enabled by the bridge
multicast filtering command.
The user guidelines of the bridge multicast mode command describe the
configuration that can be written into the FDB as a function of the FDB mode, and
the MLD version that is used in the network.
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 2

42.3 ipv6 mld snooping querier

To enable globally the MLD Snooping querier, use the ipv6 mld snooping querier
command in Global Configuration mode. To disable the MLD Snooping querier
globally, use the no form of this command.
Syntax
ipv6 mld snooping querier
no ipv6 mld snooping querier
843 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide