Ipv6 Neighbor - Cisco Sx350 Cli Manual

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example configures a DRP of high for the router on VLAN 1:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

28.24 ipv6 neighbor

Use the ipv6 neighbor command in Global Configuration mode to configure a
static entry in the IPv6 neighbor discovery cache. To remove a static IPv6 entry
from the IPv6 neighbor discovery cache, use the no form of this command.
Syntax
ipv6-address interface-id mac-address
ipv6 neighbor
ipv6-address
no ipv6 neighbor [[
Parameters
•
ipv6-address
—Specified IPv6 address. This argument must be in the form
documented in RFC4293 where the address is specified in hexadecimal
using 16-bit values between colons.
•
interface-id
—Specified interface identifier.
•
mac-address
—Interface MAC address.
Default Configuration
Static entries are not configured in the IPv6 neighbor discovery cache.
Command Mode
Global Configuration mode
User Guidelines
This command is similar to the
Use the ipv6 neighbor command to add a static entry in the IPv6 neighbor
discovery cache.
interface vlan 1
ipv6 nd router-preference high
exit
interface-id
]
arp command.
]
28
580