Ip Ssh-Client Source-Interface - Cisco Sx350 Cli Manual

Hide thumbs Also See for Sx350:

Table of Contents

—Specifies the address of an SSH server. The IP address can

be an IPv4, IPv6 or IPv6z address. See IPv6z Address Conventions.

—FIngerprint of the SSH server public key (32 Hex characters).

Default Configuration

The Trusted Remote SSH Server table is empty.

Command Mode

Global Configuration mode

User Guidelines

Fingerprints are created by applying a cryptographic hash function to a public key.

Fingerprints are shorter than the keys they refer to, making it simpler to use (easier

to manually input than the original key). Whenever the switch is required to

authenticate an SSH server's public key, it calculates the received key's fingerprint

and compares it to the previously-configured fingerprint.

The fingerprint can be obtained from the SSH server (the fingerprint is calculated

when the public key is generated on the SSH server).

The no ip ssh-client server fingerprint command removes all entries from the

Trusted Remote SSH Server table.

In the following example, a trusted server is added to the Trusted Servers table

(with and without a separator ":"):

switchxxxxxx(config)#

DC789788DC88A988127897BCBB789788

switchxxxxxx(config)#

DC:78:97:88:DC:88:A9:88:12:78:97:BC:BB:78:97:88

59.7 ip ssh-client source-interface

To specify the source interface which IPv4 address will be used as the Source

IPv4 address for communication with IPv4 SSH servers, use the ip ssh-client

source-interface Global Configuration mode command. To restore the default

configuration, use the no form of this command.

ip ssh-client server fingerprint 1.1.1.1

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide

SSH Client Commands