Table of Contents
Advertisement
28
IPv6 Commands
Default
By default, link local default zone is disabled.
Command Mode
Global Configuration mode
Example
The following example defines VLAN 1 as a default zone:
switchxxxxxx(config)#
ipv6 link-local default zone vlan1
28.12 ipv6 nd advertisement-interval
Use the ipv6 nd advertisement-interval in Interface Configuration mode to
configure the advertisement interval option in router advertisements (RAs).
To reset the interval to the default value, use the no form of this command.
Syntax
ipv6 nd advertisement-interval
no ipv6 nd advertisement-interval
Parameters
N/A.
Default Configuration
Advertisement interval option is not sent.
Command Mode
Interface Configuration mode
User Guidelines
Use the ipv6 nd advertisement-interval command to indicate to a visiting mobile
node the interval at which that node may expect to receive RAs. The node may
use this information in its movement detection algorithm.
563
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
