Arp - Cisco Sx350 Cli Manual

24
509
switchxxxxxx# show ip interface vlan 1
!source_precedence_is_supported &&
!broadcast_address_configuration_is_supported && ip_redirects_is_supported
IP Address I/F
------------- ------
10.5.230.232/24 vlan 1

24.6 arp

Use the arp Global Configuration mode command to add a permanent entry to the
Address Resolution Protocol (ARP) cache. Use the no form of this command to
remove an entry from the ARP cache.
Syntax
ip-address mac-address
arp
ip-address
no arp
Parameters
•
ip-address
—IP address or IP alias to map to the specified MAC address.
•
mac-address
—MAC address to map to the specified IP address or IP alias.
•
interface-id
—Address pair is added for specified interface.
Command Mode
Global Configuration mode
Default Configuration
No permanent entry is defined.
If no interface ID is entered, address pair is relevant to all interfaces.
User Guidelines
The software uses ARP cache entries to translate 32-bit IP addresses into 48-bit
hardware (MAC) addresses. Because most hosts support dynamic address
resolution, static ARP cache entries generally do not need to be specified.
I/F Status Type Directed
admin/oper Broadcast
----------- ------- --------
UP/UP Static disable
interface-id
[ ]
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IP Addressing Commands
Redirect Status
--------- -----
Enabled Valid